about brake lathe

Andy's Brake Lathe Silencer has been manufacturing brake lathe silencer in the U.S.A. since 1985. We our the original & only Blue Clip-On Brake Lathe Silencer.

brake lathe online store

Shop Online for Brake Lathe Silencers & Accessories.

brake lathe distrutors

Learn more on how to become a Andy's Brake Lathe Silencer Distributor.

brake lathe directions

Learn more about how to use our Clip-On Brake Lathe Silenecer.

brake lathe phone

Phone: (800) 635-2150
Fax: (951) 224-6672

made in usa

Brake Lathe Silencers
Made in the
U.S.A.

 

Directions for our Clip-On Brake Lathe Silencers.

THE UNIVERSAL PLUS
BRAKE LATHE SILENCER
CHIP DEFLECTOR

  1. IMPORTANT! Install silencer so the the TWO metal PINS are behind the cutters. Wrap the strap tight starting from the rear going toward the cutting tips over the spring, then down and around the carriage, fastening on top of the silencer (Fig.1). NOTE: The strap will attach different on some on-car lathes, the strap may have to go through the center of the carriage or around the tool holder locking lever bridge.
  2. Put lathe on automatic and the silencer will follow the cut and snap off when the cut is finished. Pressure can be adjusted by moving the spring up or back.

up draw

MADE IN U.S.A.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

On-Car Brake Lathe Silencer
and Chip Deflector

  1. Adjust the lathe to make your cut. Set
    the depth of the cut and tighten the
    knob on top of the cutting head.
  2. Adjust the spring on the silencer, if
    needed, to fit on the cutters with the
    notched edge against the cutting tips
    and with the spring behind the knob so
    that machine will follow the cut.
  3. SHUT OFF THE MACHINE.
  4. Place the silencer on the cutting head,
    notched edge against the tips, with the
    spring behind the knob on tip of the
    cutting head. You will need to use two
    hands.
  5. Turn on the machine and engage the
    clutch.
  6. When cut is finished, stop machine and
    remove the silencer.

    WARNING:
    FOR USE WITH THE PRO-CUT
    ON-CAR BRAKE LATHE ONLY

pro-cut

MADE IN U.S.A.